TUB4000
ENGLISH
Instructions translated from Italian
2 - INSTALLATION...........................................................................................................3
2.3 - Typical system ............................................................................................................................... 4
4.1 - Testing ........................................................................................................................................... 7
6 - INSTALLATION...........................................................................................................8
7.4 - Description of the electrical connections: power supply, safety and control devices,
and accessories ............................................................................................................................ 9
7.11 - Operating modes ....................................................................................................................... 13
8.1 - Testing ......................................................................................................................................... 14
8.2 - Commissioning ............................................................................................................................ 14
10.1 - Further details ........................................................................................................................... 15
10.1.2 - Other functions ....................................................................................................................... 15
10.2 - Diagnostics ............................................................................................................................... 16
12 - PRODUCT DISPOSAL ...........................................................................................17
1
Before performing any type of operation or
procedure, read carefully the general instructions
(page 1) and the application limits (paragraph 2.2)
1
PRODUCT DESCRIPTION AND INTENDED USE
TUB4000 is a sliding gate gear motor of significant dimension for industrial use,
with built-in control unit DPRO500 and is also prearranged for the inclusion of
NICE receivers.
The gear motor, which functions electrically, can be disengaged by means of a
key, thereby allowing the gate to be opened manually.
CAUTION! - All uses other than the intended use described and use
in environmental conditions other than those described in this manual
should be considered improper and forbidden!
2
INSTALLATION
The TUB4000 must be installed exclusively by qualified technical
personnel in compliance with current laws, standards and regulations,
and with the instructions provided in this manual.
2.1 - Tests prior to installation
Before proceeding with installation, check the condition of the product com-
ponents, suitability of the selected model and conditions of the intended instal-
lation environment:
• Check that all the materials are in good working order and suited to the
intended use.
• Check that all conditions of use fall within the "application limits" of the
product (paragraph 2.2) and the value limits shown in the "Product technical
characteristics".
• Check that the installation location is compatible with the overall dimensions
of the product (Fig. 1).
• Check that the surface chosen for installing the product is solid and can
ensure stable attachment.
• Make sure that the installation area is not subject to flooding; if necessary, the
product may be installed, appropriately raised above ground level.
• Check that the space around the product allows safe and easy access.
• Check that all electrical cables to be used belong to the type listed in Table 2.
• Check that the automation has mechanical stops in both the opening and
closing phases.
2.2 - Product application limits
The data relative to the TUB4000 performances is indicated in Chapter 13
("Technical specifications") and is the only data that allows for correctly deter-
mining whether the product is suitable for its intended use.
In general, TUB4000 is able to automate gates weighing up to 4,000 kg or up
to 30 m long, according to the data shown in Table 1 below.
Length of leaf in metres
Up to 5
5÷10
10÷15
15÷20
20÷25
25÷30
Graphic represen-
tation of the cycles
40
per hour in relation
35
to the length of the
30
gate leaf.
25
20
15
10
5
0
0
IMPORTANT!
TABLE 1
Maximum cycles/hour
42
21
14
10
8
7
10
15
20
L [m]
25
30
English - 3