4. Rotate bulb holder anti-clockwise.
5. Remove bulb holder. Push bulb
into socket slightly, rotate anti-
clockwise, remove and renew
bulb.
6. Insert bulb holder into the tail light
assembly and screw into place.
Install tail light assembly in body
and tighten screws. Close covers
and engage.
7. Switch on ignition, operate and
check all lights.
Side turn signal lights
1. Prise the lamp out with a
screwdriver. Push the lamp
forward (driver's side) or rearward
(passenger's side). Then pivot the
lamp down and remove it from the
aperture.
2. Rotate bulb holder anti-clockwise.
3. Pull bulb out of the bulb holder and
renew.
4. Reinstall in reverse order.
Vehicle care
LED lights (outside rearview
mirror)
Have LED lights replaced by a
workshop.
Centre high-mounted
brake light
If the centre high-mounted brake light
is not functioning, have it checked by
a workshop.
173