Table of Contents
Advertisement
Available languages
Available languages
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Advertisement
Advertisement
Need help?
Do you have a question about the XT8500EFI and is the answer not in the manual?
Questions and answers
what is the part with the copper posts that the positive and negative battery cables hook up to, broke the post and need a replacement part
The engine running but there's no electrical output
The Generac Power Systems XT8500EFI engine may be running but not producing electrical output due to the following possible causes:
1. Circuit breaker is open – Reset the circuit breaker.
2. Poor connection or defective cord set – Check and repair the connection or replace the cord set.
3. Connected device is faulty – Connect another device that is known to be in good condition.
4. Fault in the generator – Contact an Independent Authorized Service Dealer (IASD).
5. GFCI breaker module is open – Correct the ground fault and press the reset button on the GFCI breaker module.
These steps can help diagnose and resolve the issue.
This answer is automatically generated