Bosch SM Series User Manual page 47

Errors
Remnants of food on table-
ware.
Detergent residue in the appli-
ance
Water marks on plastic parts. Due to laws of physics droplet
Cause
Washing programme selected
too weak.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
Tall narrow receptacles in
corner areas are not rinsed
adequately.
Top baskets on right and left
are not set to same height.
Lid of the detergent dispenser
is blocked by items of table-
ware parts and will not open.
The lid of the detergent dis-
penser is blocked by the tab
and will not open.
Tabs are used in the quick or
short programme. Dissolving
time of the tab is not attained.
Washing effect and dissolving
performance are reduced
after a prolonged storage time
or detergent is very lumpy.
formation on plastic surfaces
is unavoidable. After drying
water marks are visible.
Troubleshooting en
Troubleshooting
Select a more intensive washing pro-
▶
gramme.
Adjust the sensitivity of the sensors.
▶
Only remove large remnants of food
▶
and do not prerinse tableware.
Adjust the sensitivity of the sensors.
▶
Do not position tall narrow recept-
▶
acles at too great an angle or in
corner areas.
Set the top baskets on the left and
▶
right to the same level.
→ "Top basket", Page 22
Arrange tableware in the top basket
1.
tableware so the tab collecting tray is
not obstructed by tableware.
→ "Arranging tableware", Page 34
Items of tableware are blocking the
dispenser lid.
Do not place tableware or fragrance
2.
dispensers in the tablet collecting
tray.
Position the tab in the detergent dis-
▶
penser crosswise, not vertically.
Select a more intensive Programme
▶
or use Powder detergent → Page 31.
Change your detergent → Page 31.
▶
Select a more intensive programme.
▶
Position tableware at an angle.
▶
→ "Arranging tableware", Page 34
Use rinse aid.
▶
→ "Rinse aid", Page 30
Set the water softening system
▶
higher.
47