Bosch SM Series User Manual page 46

en Troubleshooting
Errors
Tableware is not dry.
Plastic tableware is not dry.
Cutlery is not dry.
Appliance interior still wet
after wash cycle.
Remnants of food on table-
ware.
46
Cause
Tableware removed too early
or drying process not yet
ended.
Rinse aid used has a limited
drying performance.
Not a fault. As plastic does not
store heat so well, it also does
not dry as well.
Cutlery not arranged properly
in the cutlery basket or cutlery
drawer.
Not a fault. The condensation
drying principle causes water
droplets in the tub – they are
indeed desirable here. The
moisture in the air condenses
on the inside walls, runs off
and is pumped out.
Tableware was placed too
close together.
Basket is overfilled.
Spray arm rotation is blocked.
Spray arm nozzles are
blocked.
Filters are soiled.
Filters are inserted incorrectly
and/or not engaged.
Troubleshooting
Wait until the programme ends.
1.
Only remove tableware 30 minutes
2.
after the programme has ended.
Use a name-brand rinse aid.
▶
Eco products may have limited effect-
iveness.
No remedial action possible.
▶
Arrange the cutlery properly.
1.
→ "Arranging tableware", Page 34
Arrange cutlery individually where
2.
possible.
Avoid points of contact.
3.
No action required.
Arrange tableware with sufficient
1.
space in between.
The spray jets must reach the sur-
faces of the tableware.
Avoid points of contact.
2.
Arrange tableware with sufficient
1.
space in between.
The spray jets must reach the sur-
faces of the tableware.
Avoid points of contact.
2.
Arrange tableware so that it does not
▶
obstruct spray arm rotation.
Clean the Spray arms → Page 42.
▶
Clean the filters.
▶
→ "Cleaning filters", Page 41
Insert the filters properly.
1.
→ "Filter system", Page 41
Engage the filters.
2.