Vermont Castings VCS5017 User's Manual & Assembly page 20

VCS4007 / VCS4017 / VCS4027 / VCS4037 / VCS5007 / VCS5017 / VCS50 27 / VCS50 37 Assembly
Step 2: Install the Casters
Parts Required: (4) Casters, (1) Block (not included)
Casters (wheels) may differ from those shown in
Note:
the illustration depending on the model you purchased.
Select a side to begin installing the casters. Place a block
of wood, a telephone book or anything else available -
approximately 6 inches thick -under the side to support
the weight of the barbecue. Next, insert the pin on the top
of the caster into their respective holes located on the
6" - 8"
(152 - 203mm)
bottom, near the front and rear corners. If you have any
Fig. 2
difficulty snapping them into place, try rocking the
castors in a circular motion. When both casters are in
place, repeat the same procedure on the opposite side.
Step 3: Install U-Clip Fasteners
Parts Required:
(4) #10-20 U-Clip Fasteners
(1) Left Side Shelf Support, (1) Left Side Shelf
(1) Right Side Shelf Support, (1) Right Side Shelf
Install the one (1) U-Clip fastener to each of the Side
Shelf Supports as shown in Fig. 3a. One (1) U-Clip
should be placed on each bracket, with the flat side
down.
Fig. 3a
Install the one (1) U-Clip fastener to each of the Side
Shelves as shown in Fig. 3b. One (1) U-Clip should be
placed on the under side of each shelf, at the front
outside corner, with the flat side out.
F R
Fig. 3b
O N
T
Page 2