Lighting The Rotisserie Burner; Match Lighting The Rotisserie Burner - Vermont Castings VC50 User Manual

Lighting the Rotisserie Burner (Model VC75)
The Rotisserie burner provides the steady, even heat required to cook poultry and roasts to self-basted perfection.
To start the Rotisserie burner :
1. Always open the Hood completely before attempting to light the Grill.
WARNING : Never stand with your head directly over the Grill when preparing to light the Rotisserie burner,
to prevent possible bodily injury.
2. Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.
3. Turn on the propane gas supply valve at the tank (1 to 2 turns) or turn on the main natural gas supply valve.
4. Turn the Rotisserie Burner Control Knob to the HI position, by pushing down on the knob and turning it
counterclockwise.
5. Immediately turn the Igniter Button. The Rotisserie burner should light within four clicks.
• WARNING : IF THE ROTISSERIE BURNER DOES NOT LIGHT, immediately
turn the burner control knob to the OFF position, to prevent gas buildup.
Wait five (5) minutes for the gas to clear and then repeat the preceding
starting procedure. If the burner will not light when using the Piezo
Igniter, follow the match lighting instructions below.
6. Confirm that the burner is properly lit and that the flame pattern is as
desired, (see Figs. 9a, 9b & 9c, for the proper flame patterns). If the
flame pattern is other than normal, consult the Troubleshooting
Guide on Page 26 for corrective action.
7. Always preheat the Grill before starting to cook on the rotisserie.

Match Lighting the Rotisserie Burner

1. Always open the Hood completely, before attempting to light the Grill.
WARNING : Never stand with your head directly over the Grill when
preparing to light the Rotisserie Burner, to prevent possible bodily injury.
2. Always confirm that all of the burner control knobs are in the OFF
position before opening the gas supply.
3. Turn on the propane gas supply valve at the tank (1 to 2 turns) or
turn on the main natural gas supply valve.
4. Insert a lit match or a butane lighter into the match lighting hole located
below the rotisserie screen (see Fig. 11).
5. Turn the Rotisserie Control Knob to the HI position by pushing down on the
knob and turning it counterclockwise.
Page 10
Operation
Rotisserie
Lighting Hole
Fig. 11