Lighting The Rotisserie Burner; Match Lighting The Rotisserie Burner - Vermont Castings VCS Series User Manual

Operation
lighting the rotisserie Burner (if applicable)
The Rotisserie burner provides the steady, even heat required to cook poultry and roasts to self-basted
perfection.
WarnInG
Never stand directly over the Grill when lighting the main burners, to avoid exposure to possible flare-
ups.
TO sTarT THe rOTIsserIe BUrner:
1. Always open the Hood completely before attempting to light the Grill.
. Always confirm that all of the burner control knobs are in the OFF position before opening the gas sup-
ply.
3. Turn on the Propane Tank Valve at the tank (1 to  turns) or turn on the main natural gas supply valve.
4. Turn the Rotisserie Burner Control Knob to the HIGH position, by pushing down on the knob and turn-
ing it counterclockwise.
5. Immediately push the Igniter Button. The Rotisserie burner should light within five seconds.
IF THe rOTIsserIe BUrner DOes nOT lIGHT, immediately turn the burner control knob to
the OFF position, to prevent gas buildup. Wait five (5) minutes for the gas to clear and then repeat the
preceding starting procedure. If the burner will not light when using the Igniter, follow the match lighting
instructions below.
6. Confirm that the burner is properly lit and that the flame pattern is as desired. Refer to Figures 9a, 9b &
9c for the proper flame patterns. If the flame pattern is other than normal, consult the Troubleshooting
Guide on Page 30 for corrective action.
7. Always preheat the Grill before starting to cook on the
rotisserie.

MaTCH lIGHTInG THe rOTIsserIe BUrner:

1. Always open the Hood completely, before attempting to
light the Grill.
. Always confirm that all of the burner control knobs are in
the OFF position before opening the gas supply.
3. Turn on the Propane Tank Valve at the tank (1 to  turns)
or turn on the main natural gas supply valve.
4. Insert a lit match using the holder provided or a butane
lighter into the match lighting hole located on the left
hand side of the base. (Fig. 11)
5. Turn the Rotisserie Control Knob to the HIGH position by
pushing down on the knob and turning it counterclock-
wise.
16
Figure 11
Rotisserie
Lighting Hole
B130
30005801