2
SETUP
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Install the fork legs. (
–
Remove screws
to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handlebar support
–
Position the handlebar.
K00620-10
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp.
–
Mount screws
–
First bolt the handlebar clamp with screws
handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar clamp
–
Position the controls on the right half of the handlebar.
K00615-10
–
Position the controls on the left half of the handlebar.
–
Mount the cable tie(s).
–
Mount the fuel tank breather.
–
Install the front wheel. (
–
Install the front fender. (
–
Install the start number plate. (
K00616-10
Info
Raise the wheel slightly to be able to mount the screw more easily.
p. 10)
. Take off the handlebar clamp. Remove the handlebar and lay it
. Take off handlebar supports
and push through nuts
.
M10
but do not tighten yet.
evenly.
p. 10)
p. 11)
p. 13)
.
from below.
40 Nm
Loctite
(29.5 lbf ft)
onto the longer, higher side of the
M8
20 Nm
(14.8 lbf ft)
4
®
243™