Advertisement
3
WORK
3.5
Installing the front fender
3.6
Recharging the battery (All XC models)
Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake linings are lying correctly
against the brake disc.
K00454-11
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
M01144-10
Finishing work
–
Install the start number plate. (
.
.
p. 13)
1 m (3 ft)
9 V
M20x1.5
35 Nm
(25.8 lbf ft)
p. 9)
M8
15 Nm
(11.1 lbf ft)
and
.
M6
10 Nm (7.4 lbf ft)
11
Advertisement
