6. Preventive maintenance
This chapter contains lubrication specifications. Follow these
recommendations to prevent problems and maintain optimum performance.
Lubrication specifications
Lubricate only when parts are replaced or as needed, not on a scheduled
basis. Use grease P/N 40X0179 to lubricate the following:
•
All gear mounting studs
•
The left and right ends of the large feed roller at the side frames
•
The carrier to carrier frame engagement
•
The carrier guide rod, and carrier guide rod bearings
Warning: Keep grease from coming into contact with any electrical
components, as this may cause All-In-One damage or failure. Do not
lubricate the scanner rod or bearing after replacing.
Preventive maintenance
4416-XXX
6-1