Advertisement
Step 5.
1
Press Power Key.
CAUTION
• When the feeder lift tray is moving, do not touch it. Also, do not insert hand or place objects below the
tray. Doing so can cause injury or malfunction.
IMPORTANT
• When the status lamp (green) is blinking, the printer is preparing to print. Until the status lamp has gone from
blinking to solid green, adhere to the follow precautions. Should any of the below occur, the initial set up will be
interrupted.
-
Do not turn off the printer.
- Do not open/close the ink tank cover and the transport unit lever.
- Do not operate other controls and components of the printer.
• Follow the below procedure if the initial set up is interrupted.
-
If the printer has been turned off, turn it on again.
-
If the ink tank cover or the transport unit lever has been opened, close it.
• When the status lamp is lit (orange), any ink tank may be installed in the wrong position.
-
Confirm that the ink tank is installed in the correct position. When the ink tank cover is closed, the printer will
begin the initial set up.
-
If any ink tank is installed in the wrong position, ink colors may be mixed. In this case, execute [Shipping The
12
Turning the Printer On
When the printer is turned on, the feeder lift
tray lowers.
The printer starts the initial set up operation.
It will last approximately 20 min.
Advertisement
