Specifications - Stihl TS 410 Instruction Manual

Specifications

Engine
STIHL single cylinder two-stroke engine
TS 410
Displacement: 66.7 cm
Cylinder bore: 50 mm
Piston stroke: 34 mm
Engine power accord- 3.2 kW (4.4 HP)
ing to ISO 7293: at 9000 rpm
Idle speed: 2500 rpm
Max. spindle speed to
ISO 19432: 5080 rpm
TS 420
Displacement: 66.7 cm
Cylinder bore: 50 mm
Piston stroke: 34 mm
Engine power accord- 3.2 kW (4.4 HP)
ing to ISO 7293: at 9000 rpm
Idle speed: 2500 rpm
Max. spindle speed to
ISO 19432: 4880 rpm
Ignition system
Electronic magneto ignition
Spark plug
(suppressed): Bosch WSR 6 F
Electrode gap: 0.5 mm
TS 410, TS 420
Fuel system
All-position diaphragm carburetor with
integral fuel pump
Fuel tank capacity:
Air filter
3 Main filter (paper filter) and flocked wire
mesh auxiliary filter
Weight
without fuel, without abrasive wheel,
with water attachment
TS 410:
TS 420:
Without fuel, without abrasive wheel,
3
with electronic water control
TS 410:
TS 420:
Abrasive wheels
The quoted maximum permissible
operating speed of the abrasive wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Abrasive wheels (TS 410)
Outside diameter:
Max. thickness:
Bore diameter/spindle
diameter:
Tightening torque:
Composite resin abrasive wheels
Minimum outside diameter of
thrust washers:
Max. depth of cut:
3
710 cm (0.71 l)
Diamond abrasive wheels
Minimum outside diameter of
thrust washers:
Max. depth of cut:
Abrasive wheels (TS 420)
Outside diameter:
Max. thickness:
Bore diameter/spindle
diameter:
9.4 kg
Tightening torque:
9.6 kg
Composite resin abrasive wheels
Minimum outside diameter of
thrust washers:
9.9 kg
Maximum cutting depth:
10.1 kg
1)
For Japan 118 mm
2)
For Australia 118 mm
3)
When using thrust washers with an
outside diameter of 118 mm, the
maximum cutting depth is reduced
to 116 mm
Diamond abrasive wheels
Minimum outside diameter of
thrust washers:
Maximum cutting depth:
1)
For Japan 118 mm
3)
When using thrust washers with an
300 mm
outside diameter of 118 mm, the
4.8 mm
maximum cutting depth is reduced
to 116 mm
20 mm
30 Nm
English
103 mm
100 mm
103 mm
100 mm
350 mm
4.8 mm
20 mm
30 Nm
1) 2)
103 mm
3)
125 mm
1)
103 mm
3)
125 mm
39