Stihl TS 410 Instruction Manual page 26

English
Removing a cutting wheel
2
Use the combination wrench to
N
loosen and remove the hexagon
head screw (2)
Remove the front thrust washer (3)
N
from the shaft together with the
cutting wheel
24
Fitting a new cutting wheel
4
Fit the new cutting wheel (4)
N
WARNING
Note the arrows indicating the direction
of rotation on diamond cutting wheels.
Fit the front thrust washer (3). The
N
catches of the front thrust
washer (3) must engage in the shaft
grooves.
Screw in the hexagon bolt and
N
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Specifications" for the
tightening torque
Draw the locking pin out of the
N
V-belt guard
WARNING
Never use two cutting wheels at the
same time. The uneven wear creates a
risk of breaking and an injury hazard!
TS 410, TS 420