2. Install the:
a.
palmrest
b.
hard drive
c.
keyboard
d.
battery
e.
base cover
f.
SD card
3. Follow the procedure in
Heat sink assembly
Removing the heat sink assembly
1. Follow the procedure in
2. Remove the:
a.
SD card
b.
base cover
c.
battery
d.
keyboard
e.
hard drive
f.
palmrest
3. To remove heat sink:
a. Remove the 2 (M2.0x3.0) screw that secures the eDP cable bracket to the system board [1].
b. Remove the eDP cable bracket from the system [2].
c. Disconnect the eDP cable from the connector on the system board [3].
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
63