Monitoring Of Ipc - Dahua VTH5221 Series User Manual

Icon
/
/

6.5.2 Monitoring of IPC

Please add IPC before monitoring of IPC.
6.5.2.1 Add IPC
IPC added at main VTO and Express/DSS "IPC" interface will be synchronized to VTH.

The synchronized IPC cannot be deleted.
Before adding IPC, please ensure that IPC has been powered on, and connected to the

same network with VTH.
Select "Monitor > IPC".
Step 1
The system displays "IPC" interface, as shown in Figure 6-38. Press
frequently-used IPC to favorites, which will be displayed in "Favorite" tab, so as to
switch videos during monitoring.
Description
Press this key to unlock VTO remotely.
The system provides 2-channel unlock function. If the icon is gray, it
means that unlock function of this channel is not available.
Press this key to snapshot.
This key is gray if SD card is not installed.
Press this key to record. Complete recording when the call is completed
or by pressing .
Videos are stored in SD card of this VTH. If SD card is full, the earlier
videos will be covered.
This key is gray if SD card is not installed.
If VTH connects multiple VTO/IPC, press
last/next channel.
Press this key to cancel monitoring.
Press this key to speak to the other end device.
Press this key to start and the icon becomes
complete.
Table 6-8
and to switch to
. Press it again to
to add
Interface Operation 72