Table of Contents
Advertisement
The accessory support is inserted to the right and left.
Use water to clean food remains, oil and roasting juices from
the accessories.
Place the universal deep tray or the flat oven tray on the
:
support.
Significant health risks!
Do not place non-stick baking tins or trays in the oven during
self-cleaning. The intense heat removes the non-stick surface
and creates toxic gases.
Care and cleaning
If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
Different colours may be seen in your front panel due to the
■
various materials used in its manufacture, such as glass,
plastic and metal.
Dark patches in the door's glass panel may seem to be dirt
■
but they are in fact reflections from the oven light.
Enamel burns at very high temperatures. This may cause
■
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.
Cleaning products
Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
abrasive or acidic cleaning products
■
strong products containing alcohol
■
scourers or hard sponges
■
high-pressure or steam cleaners.
■
Wash new dishcloths thoroughly before use.
14
Setting the cleaning level
Once the cleaning level has been selected, set the oven.
V
Press the
button.
1.
†
The cleaning level 3 is displayed. Self-cleaning can be started
directly with the
button.
If you wish to change the cleaning level:
2.
Select the cleaning level with the control knob.
†
Start with the
button.
3.
The oven door is locked after starting. The
up. The oven door cannot be opened until the symbol is no
longer displayed.
Once cleaning has finished
‹
The oven stops heating.
Cancelling cleaning
H
Switch the oven off with the
door until the
symbol disappears.
Adjusting the cleaning level
Once cleaning starts, the cleaning level can no longer be
changed.
Cleaning must take place at night
Cleaning can be programmed at night so the oven is available
during the day.See the Time functions chapter, delay cooking
time.
After using the self-clean function
Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
Zone
Cleaning products
Front panel
Hot water and a little soap:
Clean with a dishcloth and dry with a soft
cloth. Do not use a glass cleaning product
or a glass scraper.
Stainless steel Hot water and a little soap:
Clean with a dishcloth and dry with a soft
cloth. Immediately remove any water
marks, grease, cornflower or egg white
stains since corrosion could occur under-
neath these marks or stains.
Special products for the care of stainless
steel which are suitable for hot surfaces
may be obtained from Technical Assist-
ance Service centres and specialist retail
outlets. Use a very fine soft cloth to apply
the cleaning product.
Glass panel
Glass cleaning products:
Clean with a soft cloth. Do not use a glass
scraper.
Display
Glass cleaning products:
Clean with a soft cloth. Do not use alcohol,
vinegar or other abrasive or acidic cleaning
products.
Glass panels on
Glass cleaning products:
oven door
Clean with a soft cloth. Do not use a glass
scraper.
H
lock symbol lights
‹‹
:
is shown on the clock display.
‡
button. Do not open the oven
Hide quick links:
Advertisement
Table of Contents
