Tektronix Keithley SourceMeter 2410 Service Manual page 12

1-2 Performance Verification
Introduction
Use the procedures in this section to verify that Model 2410 accuracy is within the limits
stated in the instrument's one-year accuracy specifications. You can perform these verification
procedures:
•
•
•
•
WARNING
NOTE
When you first receive the instrument to make sure it was not damaged during shipment.
To verify that the unit meets factory specifications.
To determine if calibration is required.
Following calibration to make sure it was performed properly.
The information in this section is intended for qualified service personnel
only. Do not attempt these procedures unless you are qualified to do so.
Some of these procedures may expose you to hazardous voltages, which
could cause personal injury or death if contacted. Use standard safety
precautions when working with hazardous voltages.
If the instrument is still under warranty and its performance is outside specified
limits, contact your Keithley representative or the factory to determine the
correct course of action.