Advertisement
Quick Links
Keithley Instruments, Inc.
28775 Aurora Road
Cleveland, Ohio 44139
1-800-935-5595
http://www.keithley.com
Description
The Model 2450-CAL-KIT is a measurement fixture that provides a stable load connection to and from all
recommended 2450 calibration equipment. This fixture is required for accurate calibration over all ranges and
polarities.
Refer to the Model 2450 Interactive SourceMeter® Instrument Calibration Manual for full usage instructions. The
Calibration Manual (part number: 2450-905-01) can be found on the
(http://www.keithley.com/support).
071337300 / July 2014
Figure 1: Model 2450-CAL-KIT
*P071337300*
Model 2450-CAL-KIT
Calibration Fixture Information
Keithley Instruments support website
1
Advertisement
Related Manuals for Tektronix Keithley 2450-CAL-KIT
Summary of Contents for Tektronix Keithley 2450-CAL-KIT
- Page 1 Model 2450-CAL-KIT Keithley Instruments, Inc. Calibration Fixture Information 28775 Aurora Road Cleveland, Ohio 44139 1-800-935-5595 http://www.keithley.com Description The Model 2450-CAL-KIT is a measurement fixture that provides a stable load connection to and from all recommended 2450 calibration equipment. This fixture is required for accurate calibration over all ranges and polarities.
- Page 2 Safety precautions The following safety precautions should be observed before using this product and any associated instrumentation. Although some instruments and accessories would normally be used with nonhazardous voltages, there are situations where hazardous conditions may be present. This product is intended for use by qualified personnel who recognize shock hazards and are familiar with the safety precautions required to avoid possible injury.
- Page 3 For safety, instruments and accessories must be used in accordance with the operating instructions. If the instruments or accessories are used in a manner not specified in the operating instructions, the protection provided by the equipment may be impaired. Do not exceed the maximum signal levels of the instruments and accessories, as defined in the specifications and operating information, and as shown on the instrument or test fixture panels, or switching card.