Clock Functions - Zanussi ZOB38903 User Manual

Residual heat function
With the Duration
deactivates automatically some minutes before
the time period ends. The oven uses the
residual heat to complete the cooking without
energy consumption.
The residual heat function is
applicable only if the Duration
more than 20 minutes.
Fast heat up function
The Fast Heat Up function works only if the
necessary temperature is 100 °C higher than
the current temperature in the oven.

Clock functions

Clock functions table
Clock function
Time of day
Minute Minder
Duration
End
You can use the functions Duration
and End
set the time for how long the
appliance should operate and when
the appliance should deactivate.
This lets you activate the appliance
with a delay in time. First set the
Duration and then the End
Setting the clock functions
For Duration and End
function and temperature. This is not necessary
for the Minute Minder
oven function".
1. Press again and again until the symbol
for the necessary clock function flashes.
8
function, the oven
is
To set, change or check the time of day.
To set countdown time. This function has no effect on the operation of
the appliance.
To set the cooking time of the oven.
To set the time of day when the oven should deactivate.
at the same time to
.
, set an oven
. Refer to "Setting an
With the Fast Heat Up function you decrease
the preheating time. You can use it with each
oven function except Keep Warm and Defrost.
WARNING!
Do not put the food into the oven
until the Fast Heat Up function is
completed.
1. Set an oven function. If necessary, change
the temperature.
2. Press .
The display shows FHU. The Fast Heat Up
function starts to operate.
When the Fast Heat Up function is completed,
an acoustic signal sounds. FHU goes out. The
set oven function continues to operate.
3. Put the food in the oven.
Application
2. Press or to set the necessary clock
function.
The display shows the symbol for the clock
function you set. When the set time ends, the
symbol flashes and an acoustic signal sounds
for two minutes.
With the Duration
functions, the appliance deactivates
automatically.
3. Press a button to stop the signal.
4. Deactivate the appliance.
Cancelling the clock functions
1. Press again and again until the symbol
for the necessary clock function and
flash in the display.
2. Press and hold the button
function goes out.
and End
until the clock
www.zanussi.com