WEIDER CLUB C725 User Manual page 9

5. Apply grease to an M10 x 175mm Bolt (42).
Attach the Backrest Frames (8) to the Bench
Frame (1) with the Bolt, two M10 Washers (83), a
33mm Spacer (52), and an M10 Nylon Locknut
(116). Set the end of the Backrest Post (7) in one
of the slots in the Bench Frame. Do not over-
tighten the Nylon Locknut; the Backrest
Frames must pivot easily.
See step 4. Tighten the M10 Nylon Locknut
(116) and the four M6 x 40mm Screws (140). Do
not overtighten the Nylon Locknut; the
Backrest Post (7) must pivot easily.
6. Attach the Weight Tube (5) to the Leg Lever (4)
with an M8 x 60mm Button Bolt (95), two M8
Washers (84), a 12.5mm Spacer (138), and an M8
Nylon Locknut (139). Make sure that the Spacer
is inside the Leg Lever.
Next, press a 25mm Round Outer Cap (45) onto
the indicated end of the Weight Tube (5). Then,
slide the Olympic Adapter (46) onto the Weight
Tube. Attach the Olympic Adapter with an M8 x
10mm Set Screw (49).
7. Apply grease to the barrel of an M10 x 70mm Bolt
Set (118). Attach the Leg Lever (4) to the Front
Leg (3) with the Bolt Set. Make sure that the
barrel of the Bolt Set is inserted through both
sides of the bracket on the Front Leg.
5
Grease
42
83
8
52
6
139
49
46
7
Grease
118
4
9
7
83
116
1
4
84
45
138
84
5
95
118
3