WEIDER CLUB C725 User Manual page 21

38. Wrap the Arm Cable (82) over a "V"-pulley (75).
Attach the "V"-pulley, a Large Cable Trap (77),
and two Full Pulley Guards (76) to the other side
of the bracket on the Center Upright (13) with an
M10 x 63mm Button Bolt (133), an M10 Washer
(83), and an M10 Nylon Locknut (116). Make
sure that the Large Cable Trap is oriented to
hold the Cable in the groove of the "V"-pulley.
39. Apply grease to an M8 x 25mm Shoulder Bolt
(143). Attach the Arm Cable (82) to the Right Arm
(23) with the Shoulder Bolt and an M8 Nylon
Locknut (139). Make sure that the end of the
Cable is turned so the flat side is facing
downward as shown in the inset drawing.
40. See inset drawing A. Apply grease to the right
Trunnion (70). Then, slide a Swivel Bracket (31)
onto the right Trunnion. Next, insert the cabling
rod into the right side of the Top Frame (17) as
shown.
See inset drawing B. Identify the High Cable
(81). Orient a Swivel Bracket Bearing (72) so that
the slots are on the indicated side, and slide it
onto the Cable. Next, attach the Cable to the
cabling rod. Pull the opposite end of the cabling
rod until the Cable is routed through the Top
Frame. Then, remove the cabling rod.
See inset drawing B. Tighten the Swivel Bracket
Bearing (72) into the Trunnion (70).
Wrap the High Cable (81) over a Small Pulley
(74). Insert the Small Pulley and the Cable into a
Bracket Guard (149); make sure that the Cable
is under the indicated rod. Next, attach the
Bracket Guard and the Small Pulley inside the
Swivel Bracket (31) with an M10 x 60mm Button
Bolt (136), two M10 Washers (83), two Pulley
Caps (73), two 6.5mm Spacers (100), and an
M10 Nylon Locknut (116) as shown.
38
133
83
76
39
143
Grease
139
23
40 A
Cabling
Rod
31
Grease
B
Cabling
Rod
81
72
Slots
136
83
100 31
73
149
Rod
81
74
21
75
77
82
76
116
13
82
143
17
70
31 70
17
100
73
83
116
82