Maintenance; Tightening The Cables - WEIDER CLUB C725 User Manual

MAINTENANCE

Make sure that all parts are properly tightened each time the weight bench is used. Replace any worn parts
immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent; do not
use solvents to clean the weight bench.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight bench, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. See ADDING WEIGHTS TO THE
WEIGHT CARRIAGE in the ADJUSTMENT section of this manual. Add some weights to the weight carriage.
Slack can be removed from the cables several ways:
Remove the M10 Nylon Locknut (116) and the M10 x
52mm Button Bolt (135) from the two Half Pulley
Guards (91), the Small Cable Trap (93), and the
Small Pulley (74) near the lower end of the two Pulley
74
Plates (92). Reattach the Small Pulley, Small Cable
Trap, and Half Pulley Guards to a hole closer to the
116
92
center of the Pulley Plates. Make sure that the
91
91
Small Cable Trap is in the proper position and
that the Low Cable (80) and Small Pulley move
74
smoothly.
135
93
If necessary, adjust the position of the Small Pulley
80
(74) near the upper end of the Pulley Plates (92) in
the same way.
See the inset drawing. Tighten the M8 Nylon
Locknut (139) that connects the end of the Low Cable
(80) to the "U"-bracket (90).
Remove the M10 Nylon Locknut (116) and the M10 x
74
52mm Button Bolt (135) from the two Half Pulley
93
116
Guards (91), the Small Cable Trap (93), and the
91
91
Small Pulley (74) attached to the "U"-bracket (90).
135
Reattach the Small Pulley, Small Cable Trap, and Half
90
Pulley Guards to a lower hole in the "U"-bracket.
80
Make sure that the Small Cable Trap is in the
proper position and that the Low Cable (80) and
Small Pulley move smoothly.
90
139
80
Do not overtighten the cables. If a cable tends to slip off the pulleys often, it may have become twisted.
Remove the cable and re-install it. If a cable needs to be replaced, see ORDERING REPLACEMENT PARTS
on the back cover of this manual.
33