Vetter Smartfork Operating Instructions Manual page 44

Maintenance of the SmartFork
Maintenance activities > Replacing components
EN
Removing the
weighing elec-
tronics
Installing the
weighing elec-
tronics
6.2.7.3 Replacing load cells
44
® Scale
Fig. 17: Replacing the weighing electronics
2.
Remove the fork shoe from the SmartFork
on page 41).
3. Unscrew and remove the two screws from the cover (Fig. 17/1).
4. Remove the cover (Fig. 17/1) and put it to one side.
5. Disconnect the cable connections (Fig. 17/3) on both sides of the weighing elec-
tronics by unplugging them.
6. Remove the weighing electronics (Fig. 17/2).
1. Establish the cable connections on both sides of the weighing electronics
(Fig. 17/3).
2. Insert the weighing electronics (Fig. 17/2) into the recess.
3. Put the cover (Fig. 17/1) on the recess and fasten it.
4.
Install the fork shoe of the SmartFork
on page 43.
Personnel:
n
Protective equipment: n
n
n
n
Special tool: n
SmartFork
® Scale (
®
Scale
Service specialist
Protective clothing
Industrial safety helmet
Protective gloves
Safety shoes
Torque wrench
®
Scale weighing fork arms
Ä "Removing the fork shoe"
Ä "Installing the fork shoe"
V1.02/2020