Vetter Smartfork Operating Instructions Manual page 31

Position of the
lift mast
Fig. 11: Tilt of the lift mast
Ground condi-
tions/plane
Ground con-
tact
V1.02/2020
Weight determination with the SmartFork® Scale > Prerequisite for correct weight determination
NOTICE!
Tilt angle of the lift mast
The lift mast must not exceed the vertical by a tilt angle of a = +/- 3°. If
this tilt angle is exceeded, a warning appears on the SmartDisplay and
measurement is no longer possible.
– Align the lift mast at an angle of 90° to the ground prior to measure-
ment.
NOTICE!
Permissible ground incline/gradient!
The industrial truck must be on level ground in order to conduct a reliable
measurement with the SmartFork
Inclines or gradients > 5° lead to incorrect weight indications.
– Always move the industrial truck onto level ground before starting the
measurement.
NOTICE!
No functionality if there is ground contact!
®
The SmartFork Scale is not operational until it is raised off of the ground
slightly.
– Prior to measurements, ensure that the SmartFork
have any contact with the ground.
®
SmartFork Scale weighing fork arms
Operation of the SmartFork
® Scale.
®
Scale does not
® Scale
EN
31