Operator Obligations - Vetter Smartfork Operating Instructions Manual

Intended use includes observation of all the information in this manual.
Any use that goes beyond the scope of intended use is considered incorrect use.
The use of the SmartFork
on the back of the fork, Fig. 2) is considered incorrect use.
2.4

Operator obligations

Operator
The operator is the person who operates the SmartFork
industrial or commercial purposes, or who delegates use to a third party and bears the
legal product responsibility during operation for the protection of personnel or third par-
ties.
V1.02/2020
WARNING!
Risk of injury from incorrect use!
Incorrect use of the SmartFork
and serious injuries.
– Never neglect the general requirements for safety and due diligence. If
in doubt, personally ensure that there are no people or obstacles in the
danger zone of the industrial truck.
– Do not exceed the maximum load capacity of both SmartFork
used.
– Never install the SmartFork
ible with the SmartFork
ating instruction for the fork carrier installed on the industrial truck.
– Never use the SmartFork
– Never use the SmartFork
– Never use the SmartFork
– Never use the SmartFork
– Never use the SmartFork
perature range of -10 °C and +40 °C.
– Never expose the SmartFork
mitted to insert or pull out of the pallet/load at an angle, or to push the
pallet/load from the side.
– Never use the SmartFork
dler.
– Only use (when unloaded) the SmartFork
with an approved warning system (e.g. warning bars) as per the road
traffic regulations.
– Never use industrial trucks equipped with the SmartFork
areas subject to explosion hazards.
– Never allow unauthorised persons access to the industrial truck.
– Never allow insufficiently qualified persons to carry out maintenance or
troubleshooting work.
– Never skip a maintenance interval.
– Never modify the SmartFork
® Scale without the prescribed safety markings (hard stamping
®
SmartFork Scale weighing fork arms
®
Scale could lead to dangerous situations
®
Scale on a fork carrier that is incompat-
®
Scale supplied. Observe the relevant oper-
® Scale to lift or transport people.
® Scale for demolition work.
®
Scale as reversible fork arms.
®
Scale separately or load it unevenly.
®
Scale at temperatures outside the tem-
® Scale to lateral forces. It is not per-
® Scale on a rotary device or on a pallet han-
®
Scale for road transport
® Scale independently.
®
Scale on an industrial truck for
Safety
Operator obligations
EN
®
Scales
®
Scale in
11