Table of Contents
Advertisement
ELECTRICAL SAFETY
WARNING - THIS APPLIANCE MUST BE EARTHED.
ONLY USE AT THE VOLTAGE SHOWN ON THE LABEL.
The colours of the mains lead of this machine may not correspond with the coloured
markings identifying the terminals in your plug. Therefore proceed as below:
the earth wire is coloured green and yellow and must be connected to the earth
terminal in the plug marked with the letter E or by the earth symbol
oured green and yellow.
the neutral wire is coloured blue and must be connected to the neutral terminal
marked with the letter N or coloured black.
the live wire is coloured brown and must be connected to the live terminal marked
with the letter L or coloured red.
the IP rating referred to on the label of this machine applies to the motor enclo-
sure only.
The machine should be fitted with a latching 16 amp mains plug to BS 4343/CEE 16
or equivalent. If this or any other type of unfused plug is used, a 5 amp fuse must be
fitted at the fuse board. In the U.K. a 13 amp mains plug to BS 1363A, fitted with a 3
amp fuse, should only be used where this is suitable, taking into account the working
environment, and where the method of operation will not cause the mains connection
to be put under strain. The use of a residual current circuit breaker, preferably incor-
porating a supply failure automatic drop out facility, is strongly recommended.
An extension lead of up to 80 metres may be fitted using a suitable waterproof cable
connector. The lead should be of heavy duty 3 core flexible cable and of a conductor
size not less than 1.0 mm² (32/0.2 mm). This is essential to avoid excessive voltage
drop. Use the extension lead fully unreeled to prevent overheating. A faulty cable
must be replaced. Ensure the cable does not make contact with the rotating atomiser
disc.
ALL ELECTRICAL CONNECTIONS MUST BE PROPERLY MADE.
DOUBT CONSULT A QUALIFIED ELECTRICIAN.
2
or col-
IF IN
Advertisement
Table of Contents
