Festo MPA-F Series Manual page 181

B. Supplementary component summary
B.2 Isolating the MPA−F valve terminal from the CPX terminal
1
CPX Terminal
2
Pneumatic
interface
3
MPA−F valve
terminal
Fig. B/1: Pneumatic interface
Dismounting
Festo P.BE−MPAF−EN en 0910a
The MPA−F valve terminal is connected to the CPX terminal by
means of a pneumatic interface (see following Fig. B/1).
1 2 3
Proceed as follows:
1. Loosen the electrical and pneumatic connections and
remove the MPA−F valve terminal from its fastening
surface (see chapter 5, section 5.2).
2. Release the retaining screws between the pneumatic
interface and the MPA−F manifold block (see Fig. B/2).
3. Then remove the retaining screws.
B−11