Unit Installation - Midea ECOHEAT Series User Manual

3. UNIT INSTALLATION

3.1 Installation Instruction
① Check the capacity of power circuit (circuit breaker, wires, etc.)
②
Power cord installation;
③
Water heater installation;
④
Plumbing connection;
⑤ Power supply connection;
⑥ Water Supply.
3.2 Power Cord Installation
Step 1
Remove the screws at the bottom of the unit. Lift
the Main Switch Knob and Power Knob to make it
free. Remove the front plate gently.
Step 3
Gash the middle of the film of the power cord
jacket with a sharp knife in order to put into
power lines.
Step 5
Tighten the wire-pressing plate with screws to
primary position, ensure that the power cord not
be pulled out more than 60N.
Step 2
Remove the power cord wire pressing plate and
keep the screws.
Step 4
Insert by turning the power cord into the jacket for
installation of wire pressing plate.
Step 6
Connect the power cord to wiring terminals; the
method is as shown in picture.
7