Lancom Office Series Manual page 20

20
Introducing the LANCOM Office
1
1 On/off switch
2 Connection for the power adapter
Only use the included power supply unit! Using an unsuitable power supply
may cause damage or injury.
3 Reset switch – For setting the device into the delivery state, push the set
4 10/100Base-Tx for the connection to the LAN. Supported are 10 Mbps or
5 Node/Hub switch – for a direct connection of a single PC, the Rx and Tx
6 V.24 serial configuration port
7 ISDN S
8 10Base-T-port for DSL or cable modem (not LANCOM 800 Office)
| |
LANCOM Office
|
2 3 4 5
reset bottom and press it for approximately 5 seconds. As soon as the
reset switch is released, the front panel LEDs of the device will light up
and the device will be reset to the factory-default state.
100 Mbps connections. LANCOM Office identifies automatically the used
network speed (autosensing).
wires of the LAN connector 4 can be crossed within the device ('hub' set-
ting).
When you connect to an external hub or switch, it should be set to the
'Node' position (presetting).
port
0
6 7 8