Priority Watch; Add/Remove Channels From Scan Memory - Uniden UH400SX Owner's Manual

UNIDEN Model UH400SX, UH400SX-RM, UH500SX, UH500SX-RM OM
Operation

Priority Watch

To switch Priority Watch On/Off;
[MENU/ENTER]
1. Press
2. Turn the Rotary Channel Selector at the base or press
change the setting between ON or OFF.
[MENU/ENTER]
3. Press
4. Press and hold
If SCAN is deactivated while it is tuned to an active channel, the UHF CB Radio
will stay on that active channel.
If none of the channels are active, the UHF CB Radio will reinstate the scan start
channel.
If OS/GS Scanning is initiated when there are no channels programmed in
OS/GS memory, an error tone will be heard and scanning will not start (see
Programming Scan Channels - below).

Add/Remove Channels from SCAN Memory

Select which Scanning Mode you wish to use
- OS or GS.
Select the channel you want to store.
[MEM]
Press to store. MEM icon appears
and a short tone beep is heard.
To remove the channel from SCAN memory,
[MEM]
press once more.
The MEM icon disappears.
uh400sx, uh500sx, uh400sx-RM, uhSec1:24 Sec1:24 uh400sx, uh500sx, uh400sx-RM, uhSec1:24 Sec1:24
two times. The Priority Watch setting fl ashes.
to store the setting.
[MENU/ENTER]
to exit from the menu mode.
on the Remote SPK/MIC to
24
1/2/08 1:31:28 PM 1/2/08 1:31:28 PM