Table of Contents
Advertisement
Commissioning
6
Commissioning
6.1
General wiring guidelines
The wiring is defined in the circuit diagram of the PNOZmulti Configurator.
Please note:
Information given in the
}
The position of the expansion module is specified in the Hardware configuration of the
}
PNOZmulti Configurator.
Use copper wiring with a temperature stability of 75 °C.
}
6.2
Interface configuration
Serial interface
RS232
6.3
Preparing for operation
The serial interface RS 232 is activated and detected depending on the USB interface on
the base unit:
USB interface on the base unit not connected
}
In this case, the serial interface RS 232 will be detected and activated by the base unit as
soon as the communication module has been connected to the base unit.
USB interface on the base unit connected
}
If the USB interface on the base unit is already connected, the "External" interface will
first need to be selected on the base unit display to enable the serial interface RS 232 on
the base unit to be detected and activated (see operating manual for the base unit for de-
tails of the setting).
6.4
Download modified project to the PNOZmulti system
As soon as an additional expansion module has been connected to the system, the project
must be amended in the PNOZmulti Configurator and downloaded back into the base unit.
Proceed as described in the operating manual for the base unit.
Operating Manual PNOZ m ES RS232
1002701-EN-04
Technical details [
TxD RxD
GND
NOTICE
For the commissioning and after every user program change, you must
check whether the safety devices are functioning correctly.
15]
must be followed.
Standard
TxD (Transmit)
RxD (Receive)
GND (Ground)
| 13
Advertisement
Table of Contents
