Step 5: Lift Frame; Step 6: Install Mattress Retaining Bar; Step 7: Test Remote Functions - modway MOD-6107 Assembly Instruction Manual

MOD-6107/ MOD-6108 ELECTRIC ADJUSTABLE BED
Step 5:
With the help of your able-bodied assistant, carefully lift the adjustable bed frame and set it in place upright on its
legs. Excessive pressure may damage the legs. Remove all protective plastic covering.
Note: check to make sure that all power cords are clear and do not interfere with any Adjustable Bed Mechanisms.
Step 6:
Note: The Mattress Retaining Bar is retained on the back of the bed for shipping only. Remove the Mattress
Retaining Bar, turn the bar upright, and re-install by carefully aligning and pushing the bar ends into grooves.
Then pull the bar to secure the bar into place. (See Figure below.)
Step 7:
Test all functions on remote controller.
Synchronize the remote with the control box. First, make sure batteries are in the remote control, per Figure 3.
Next, find the black box mounted under the bed. In Figure 4, the red arrows show the Head up button and Foot up
button on the wireless remote, and the larger inset circle shows a small button on the side of the control box cord.
Hold both the Head up button and Foot up button on the remote. While holding the buttons, press the small button
on the extension cord. You will hear three quick beeping sounds. Press the Head Up button and quickly release;
the adjustable bed should be working after matching the remote with the control box.
Customer Service 908-368-1025︱www.modway.com
Page 5 of 6