Configuring Network Addressing For Your Network - 3Com -1623 Getting Started

20 C
ONFIGURING
5 Enable dynamic dial on the port.
a In the Dial on Demand Dynamic Dial section of the
b In the start field, choose 4.
c In the CONTrol field, choose Enabled.
d Click Apply.
Configuring Network Addressing for Your Network
To configure network addressing, use either "Configuring
IP Network Addressing" or "Configuring IPX Network
Addressing," depending on which protocol your network
uses.
Configuring IP Network Addressing
Use this procedure when you use IP as your network
protocol. If you use IPX as your network protocol, go to
"Configuring IPX Network Addressing" on page 23.
To configure IP network addressing, follow these steps:
1 Obtain an address range to be assigned as the address pool
for the DHCP server from your network administrator.
2 Assign the new IP address pool to the DHCP server.
a In the Basic IP section of the navigation frame, click the
b In the start field, choose 1.
c In the AddressPool field, enter a DHCP address pool. For
d Click Apply.
3 Enable the new DHCP address pool.
a In the Basic IP section of the navigation frame, click the
a In the start field, choose 1.
b In the CONTrol field, choose AddressPool.
Y O C
OUR FFICE
navigation frame, click the PORT CONTrol link.
DHCP AddressPool link.
example, enter:
20.1.0.2 - 20.1.0.254
DHCP CONTrol link.
NETB
ONNECT UILDER
10 B /R
RIDGE OUTER