BFT RIGEL 5 Installation And User Manual
Universal control unit for operating one or two motors
Hide thumbs
Also See for RIGEL 5:
- Installation and user manual (56 pages) ,
- Quick reference (10 pages) ,
- Installation and user manual (19 pages)
Advertisement
Quick Links
CENTRALINA UNIVERSALE PER IL CONTROLLO DI UNO O DUE MOTORI
UNIVERSAL CONTROL UNIT FOR OPERATING ONE OR TWO MOTORS
UNITE DE COMMANDE UNIVERSELLE POUR LE CONTROLE D'UN OU DEUX MOTEURS
UNIVERSALSTEUERUNG FÜR EINEN ODER ZWEI MOTOREN
CENTRAL UNIVERSAL PARA EL CONTROL DE UNO O DOS MOTORES
CENTRAL UNIVERSAL PARA O CONTROLO DE UM OU DOIS MOTORES
Attenzione! Leggere attentamente le "Avvertenze" all'interno! Caution! Read "Warnings" inside carefully! Attention! Veuillez lire attentivement les Avertissements qui se trouvent à l'intérieur! Achtung! Bitte lesen Sie
aufmerksam die „Hinweise" im Inneren! ¡Atención¡ Leer atentamente las "Advertencias" en el interior! Let op! Lees de "Waarschuwingen" aan de binnenkant zorgvuldig!
Advertisement
Related Manuals for BFT RIGEL 5
Summary of Contents for BFT RIGEL 5
- Page 1 CENTRALINA UNIVERSALE PER IL CONTROLLO DI UNO O DUE MOTORI UNIVERSAL CONTROL UNIT FOR OPERATING ONE OR TWO MOTORS UNITE DE COMMANDE UNIVERSELLE POUR LE CONTROLE D’UN OU DEUX MOTEURS UNIVERSALSTEUERUNG FÜR EINEN ODER ZWEI MOTOREN CENTRAL UNIVERSAL PARA EL CONTROL DE UNO O DOS MOTORES CENTRAL UNIVERSAL PARA O CONTROLO DE UM OU DOIS MOTORES Attenzione! Leggere attentamente le “Avvertenze”...
- Page 2 “trusted device” 20 21 33 34 35 36 37 LOGICA test fotocellule OFF Photocell test LOGIC OFF LOGIQUE essai photocellules Désactivée LOGIK Test Fotozellen OFF LÓGICA prueba fotocélulas OFF LOGICA test fotocellen OFF 1-PHOT RIGEL 5 -...
-
Page 3: System Settings Menu
1 Active motor ----- ----- ----- ----- ----- Gate-open or 2nd radio channel warning light Safety edge : semiautomatic operation, residential Blinking output Type of lock : automatic operation, commercial : semiautomatic operation, commercial : dead man operation RIGEL 5 -... - Page 4 1-PHOT 1-PHOT Bar 1 1-PHOT 1-BAR 1-PHOT Bar 1 Bar 1 2-PHOT 2-PHOT 2-BAR Bar 2 3-BAR 3-PHOT 3-PHOT Bar 1 Bar 2 Bar 3 4-BAR 4-PHOT 4-PHOT Bar 3 Bar 1 Bar 2 Bar 4 10 - RIGEL 5...
- Page 5 C4, C5 C4, C5 C4, C5 C4, C5 C1, C2, C3, C4, C5 C4, C5 C4, C5 C4, C5 C1, C2, C3, C4, C5 C1, C2, C3, C4, C5 SCS1 SCS1 SCS1 Max. 250m UNIDA Programmeerbare Universele Palmtop RIGEL 5 -...
- Page 6 Er1X * hardware anomaly check connections to motor * X = 0,1,…,9,A,B,C,D,E,F 18 - RIGEL 5...
-
Page 7: General Warnings
All critical points must be protected by safety devices in accordance with the provisions of the regulations in force. RIGEL 5 -... - Page 8 INSTALLATION MANUAL 1) FOREWORD DESCRIPTION TERMINAL The RIGEL 5 control unit is supplied by the manufacturer with standard GND terminal setting. Any modifications must be entered using the universal palmtop programmer or the incorporated display. This Control unit supports the 230V~±10%, 50-60Hz power supply (2 neutral, 3 phase).
- Page 9 This makes it possible to use one single command to open and close all the automation units connected. Following the diagram in Fig. E, proceed to connecting all the RIGEL 5 control panels, exclusively using a telephone-type line. Should a telephone cable with more than one pair be needed, it is indispen- sable to use wires from the same pair.
- Page 10 Exclude block maintenance. Hold-to-run operation: the manoeuvre continues as long as the command key is kept pressed. hold-to- IMPORTANT - It is not possible to use the radio transmitter. Hold-to-run Impulse operation. 22 - RIGEL 5...
- Page 11 Displays receiver code required for cloning remote controls. ON = Enables remote programming of cards via a previously memorized W LINK transmitter. It remains enabled for 3 minutes from the time the W LINK remote control is last pressed. OFF= W LINK programming disabled. RIGEL 5 -...