Stihl MSA 160 C Instruction Manual page 41

English
18 Troubleshooting
18.1 Troubleshooting Chainsaw or Battery
Condition LEDs on Battery
Saw does not start 1 LED flashes
when switched on. green
1 LED glows red.
3 LEDs flash red.
3 LEDs glow red
4 LEDs flash red.
78
Cause
Battery has low charge.
Battery too hot or too cold.
Malfunction in saw.
Chainsaw is too hot.
There is a malfunction in
the battery.
No electrical contact
between the chainsaw and
battery.
Saw or battery damp
Remedy
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300, 500
chargers.
► Engage the chain brake and remove the battery.
► Allow battery to cool down / warm up.
► Engage the chain brake and remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Disengage the chain brake.
► Switch on the saw.
► If 3 LEDs continue to flash red: Do not use your
chainsaw and contact your STIHL servicing dealer
for assistance.
► Engage the chain brake and remove the battery.
► Allow chainsaw to cool down
► Engage the chain brake, remove and refit the
battery.
► Disengage the chain brake.
► Switch on the saw.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
► Engage the chain brake, remove and refit the
battery.
► Allow saw or battery to dry
18 Troubleshooting
0458-701-9921-E