Cres Cor H-339-X-C Series Operating And Maintenance Instructions

5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
For INSULATED UNDERCOUNTER CABINETS

ELECTRICAL SPECIFICATIONS:

MODEL
H-339-X-128C,
UA-8C, 188C,
12-188C, 1813C
H-339-X-128C-240,
188C-240, 12-188C-240,
1813C-240, UA-8C-240

HOW TO INSTALL UNIT:

1. Plug cord into 15-amp wall outlet.
2. Place cabinet in a well ventilated area.
3. Insert pan slides into the cabinet.
4. Push the switch on, turn the thermostat to No. 10
and run the unit for one hour.
NOTE: DO NOT PUT IN FOOD!
This step is to burn off manufacturing oils and
excessive adhesive.
5. Let the cabinet cool and wipe inside clean with
detergent and hot water before use.
HOW TO OPERATE UNIT: (Figure 1)
1. Push switch "ON". Yellow light will come on.
2. Turn thermostat to the temperature you need.
NOTE: No. 7½ setting will give you about 180° F.
Proper food holding temperature is 140° F or
higher.
3. Preheat cabinet for 45 minutes
4. Put food into cabinet.
5. Turn the wing nut on the door vent to open the
vent when less humidity is needed.
To Turn Off Unit:
Push switch "OFF". The yellow light will go off.
NOTE: Thermometer gives the inside cabinet
temperature.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
MODEL H-339-X-C Series
Volts Watts
120 900
240 900
Insulated
Holding Cabinet
Rev. 4 (5/14)
Amps Hertz Phase
7.5 60
3.8 60
Figure 1
Control Panel
FL-2300
Page 1 of 4
NEMA
1 5-15
1 6-15