Cres Cor Fire-N-IceCube Operating And Maintenance Instructions

5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS

HOW TO INSTALL THE UNIT:

1. Remove all paper and packing materials from the
inside of the cabinet and install angles into posts.
2. Remove protective material from the door of the
cabinet.
3. Place the cabinet in a well-ventilated area on level
floor or ground.
4. DO NOT block the flue vent located at the upper
rear of the cabinet.
WARNING
BEFORE cleaning the cabinet,
allow cabinet to cool.
Cleaning hints:
1. Wipe up spills as soon as possible.
2. Clean cabinet daily to avoid heavy dirt build-up.
3. Make a test spot with cleaner:
a) Follow manufacturer's directions on cleaner.
b) Do not mix cleaners.
c) Avoid drips and splashes.

HOW TO CLEAN THE UNIT:

OUTER CABINET
(Powder Coat
and vinyl)
CABINET
Inside and
Door
(Stainless Steel)
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
HC2UA11 Fire-N-Ice Hot Cabinet

MAINTENANCE INSTRUCTIONS

Soil
WEEKLY, OR AS NEEDED
DAILY CLEANING
STUBBORN SPOTS AND
STAINS
BURNT-ON FOODS OR
GREASE
HARD WATER SPOTS
and SCALE
*Mild detergents include soaps and non-abrasive cleaners.
CAUTION
1. Do NOT use abrasives (steel wool) or harsh
chemicals (chlorine, bromine, iodine or ammonia).
2. Do NOT use a water sprayer (pressure sprayer) to
clean the cabinet.
3. Do not use Cres Clean on label or plastic
materials.
Cleaner
Mild detergent and warm
water.
Mild detergent and hot
water.
Mild abrasive made for
stainless steel.
Chemical oven cleaner for
stainless steel.
Vinegar
FL-2397
Holding Cabinet
Rev. 0 (04/17) Page 1 of 5
Method
1. Wipe with clean, soft cloth.
2. Rinse well.
3. Dry gently.
1. Sponge on with cloth.
2. Rinse with water.
3. Wipe dry.
1. Apply with damp sponge or cloth.
2. Rub lightly.
3. Rinse with water and wipe dry.
Follow oven cleaner manufacturer's
directions.
1. Swab or wipe with cloth.
2. Rinse and dry.