Advertisement
Quick Links
Advertisement
Related Manuals for Ratio Electric SMART BOX
Summary of Contents for Ratio Electric SMART BOX
- Page 1 SMART BOX DYNAMIC CHARGING + ENERGY METER M a n u a l...
-
Page 2: Important Safety Instructions
C O N T E N T S C O N T E N T S IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS SAFETY IFORMATION SAFETY INFORMATION INSTALLATION INSTALLATION OPERATION SETUP MENU FRONT PANEL DISPLAY USER INFORMATION OPTIONS SPECIFICATIONS MAINTENANCE SPECIFICATIONS FCC INFORMATION MAINTENANCE WARRANTY INFORMATION... - Page 3 Support section in this manual for service information. Do not attempt to repair or service the Smart Box yourself. Do not operate your Smart Box if it or the supply cable or housing is visibly damaged. Switch off the MCB in the electrical cabinet and contact your Service Representative for service immediately.
- Page 4 Warning: If, at any time, you think the equipment is unsafe, switch off the MCB in your electrical cabinet and immediately contact Customer Support for service. Do not use your Smart Box until the problem is identified and corrected. Caution: Children should not be allowed to use this Smart Box. Do not allow children to play in or around the Smart Box.
- Page 5 Use supplied M25 cable gland to fix charge cable. Use 4 wood screws M4,5x35mm to mount Charging Station on the wall. The Charging Station should be installed between 0,80m and 1,20m from bottom to the ground. SMART BOX / Version: EV050...
- Page 6 The data cable on the Sensorbox should be connected to terminals A (white), B (yellow), +12V (brown) and GND (green). NOTE: The data cable between Sensorbox and Smart Box is not supplied. You can use a standard UTP cable or 4 x 0,25 mm data cable.
- Page 7 In the setup CHG MODE you can choose between: SETUP CHG MODE SETUP CHG MODE <- MANUAL -> <- FIXED 16 -> SETUP CHG MODE SETUP CHG MODE <- FIXED 32 -> <- SMART -> SMART BOX / Version: EV050...
- Page 8 IMPORTANT: OUTLET VERSION - before closing outlet cover, It is possible to connect up to 4 Smart Box modules to each other and let them be sure the outlet is unlocked! share one mains supply. Configure the Smart Box’s load balancing option (LOAD BAL) and set one module to MASTER, the others to SLAVE 1,2,3.
- Page 9 To make your choice please use the left or right arrow button. To confirm press the middle button. 6. SETUP I-CALkWh SETUP CALIBRATE BUSY ALREADY <- I-CALkWh -> CALIBRATED The calibration has already been done. It is possible to calibrate the charger only once. SMART BOX / Version: EV050...
- Page 10 IMPORTANT: OUTLET VERSION - before closing outlet cover, In case of error message please contact Ratio Electric for support. be sure the outlet is unlocked! U S E R I N F O R M A T I O N 1 PHASE CHARGE STATION The charging display depends on the chosen charger mode ->...
- Page 11 The values can be deleted by pressing the left and right Et (2): arrow buttons at the same time. Et (3): With the middle button you can go back to the previous Et (4): screen. Et (5): SMART BOX / Version: EV050...
- Page 12 CHARGER with the error code. If multiple errors occur the codes will NOT READY alternate. ERR: …....…. Connect in-coming power to the left By error message please contact Ratio Electric for terminal block. support. www.ratio.nl Single Phase : L1=Brown To return into the setup menu please press the middle N= Blue button for 5 seconds.
- Page 13 If multiple errors occur the codes will NOT READY alternate. ERR: …....…. By error massage please contact Ratio Electric for www.ratio.nl support. To return into the setup menu please press the middle button for 5 seconds.
- Page 14 Warning To reduce the risk of electrical shock or equipment damage, be cautious while cleaning the connectors and case. Clean the Smart Box using a soft cloth lightly moistened with mild detergent solution. Never use any type of abrasive pad, scouring powder, or flammable solvents such as alcohol or benzene.
- Page 15 Reorient or relocate nearby electrical appliances or equipment during charging. Turn off nearby electrical appliances or equipment during charging. Caution: Changes or modifications to this product by other than an authorized service facility may void FCC compliance. SMART BOX / Version: EV050...
- Page 16 C O N T A C T / C U S T O M E R S U P P O R T Ratio Electric B.V. Ambachtsstraat 12 NL-3861 RH Nijkerk The Netherlands Tel. +31-33-2452360 info@ratio.nl www.ratio.nl SMART BOX / Version: EV050...