Mitsubishi Electric ME96SSH-MB Programming Manual page 20

7.1.2 Remote Output RY
The allocation of the remote output RY of ME96 is shown in the table below.
Device
Signal name
No.
RYn0
to
Reserved
RYnF
RY(n+1)0
Monitor pattern setting flag P00
RY(n+1)1
to
Reserved
RY(n+1)7
RY(n+1)8
Monitor pattern setting flag P08
RY(n+1)9
Monitor pattern setting flag P09
RY(n+1)A
Monitor pattern setting flag P10
RY(n+1)B
Monitor pattern setting flag P11
RY(n+1)C
Monitor pattern setting flag P12
RY(n+1)D
to
Reserved
RY(n+7)7
Initial data
RY(n+7)8
setting completion flag
RY(n+7)9
Unusable
RY(n+7)A
Error reset request flag
RY(n+7)B
to
Unusable
RY(n+7)F
*1: For the details, refet to "6.Communication Between the Master Station and ME96"
Note: The "n" in the table is determined by the station number of ME96.
Warning
Do not read or write to reserved remote registers. If reading or writing is performed, the
functions of ME96 are not guaranteed.
Description
ON（1）→OFF（0）
－
Not setting
－
Not setting
Not setting
Not setting
Not setting
Not setting
－
Cancel normal
communication request
－
Cancel error reset request
－
(20/n)
OFF（0）→ON（1）
－
Setting
－
Setting
Setting
Setting
Setting
Setting
－
Normal communication
*1
request
－
Error reset request *1
－
Note
LEN130391B