Installing The Beltclip - Uniden CXAI 5198 SERIES Owner's Manual

Installing the Beltclip

[ 1 1 ] G E T T I N G S T A R T E D
Direct wall mounting
If you don't have a standard wall plate, you can mount your phone directly to the wall.
Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location that could cause a
hazard when inserting screws into the wall.
• Try to mount your phone within 5 feet of a working phone jack to avoid excessive cord
lengths.
• Make sure the wall material is capable of supporting the weight of the base and handset.
• Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall
material where the base unit will be placed.
1) Insert two mounting screws into the wall, (with their appropriate anchoring device),
3-15/16 inches apart. Allow about 1/8 of an inch between the wall and screw heads for
mounting the phone.
2) Refer to steps 1 through 8 on page 10 to mount the telephone.
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it
clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
w w w . u n i d e n . c o m