Jasic Plasma Cut Series Operator's Manual
Hide thumbs
Also See for Plasma Cut Series:
- Operator's manual (32 pages) ,
- Operator's manual (32 pages) ,
- Operator's manual (22 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Jasic Plasma Cut Series
Summary of Contents for Jasic Plasma Cut Series
- Page 1 A WILKINSON STAR LIMITED PRODUCT 01-19 ISSUE 1...
- Page 2 Your new product Thank you for selecting this Jasic Technology, Wilkinson Star product. This product manual has been designed to ensure that you get the most from your new product. Please ensure that you are fully conversant with the information provided paying particular attention to the safety precautions.
- Page 3 Repair or replace damaged or defective parts SAFETY immediately. Carry out any regular maintenance in These general safety norms cover both arc welding accordance with the manufacturer’s instructions. machines and plasma cutting machines unless Safety against fumes and welding gases otherwise noted.
- Page 4 or pipes can cause them to explode. concentrations of combustible fumes, flammable gases and dust. Accidental contact of electrode to metal objects can cause arcs, explosion, overheating or fire. Always check the work area half an hour after cutting to make sure that no fires have begun. Check and be sure the area is safe and clear of inflammable material before carrying out any Risks due to magnetic fields...
- Page 5 which do not contain any toxic or poisonous 30K~100KHz AC high voltage. Then, the voltage is materials dangerous to the operator. dropped and rectified to output the high power DC power supply for cutting. When the equipment is scrapped, it should be The machine adopts switching power supply dismantled separating components according to the inverter technology, greatly reducing the volume...
- Page 6 ensure natural airflow. Switch off the machine at the mains supply. Input connection Remove the machine cover. Before connecting the machine you should ensure Switch on the mains supply and the machine that the correct supply is available. Details of the taking care not to touch any electrical parts.
-
Page 7: Notes On Cutting
will start. Once the arc is completely through the This may be caused by: material start to move the torch along the required The cutting speed is too low. cutting path at the correct speed. The electrode and nozzle of the torch are burned. Travelling too fast will cause blow back of material The cutting current is too high. -
Page 8: Panel Layout
PANEL LAYOUT FRONT Pressure gauge Work return socket Torch connector socket 2T/4T selector Air purge/cut selector Current adjustment knob REAR Mains switch Mains cable Air inlet A WILKINSON STAR LIMITED PRODUCT 01-19 ISSUE 1... - Page 9 CONTROL PANEL POSITION DESCRIPTION POWER INDICATOR: THIS WILL BE LIT WHEN MAINS POWER IS ON. OVERHEAT INDICATOR: THIS WILL BE LIT WHEN THE MACHINE IS IN OVERHEAT CONDITION. THE MACHINE WILL STOP WHEN THIS INDICATOR IS ON. LEAVE THE MACHINE ON UNTIL THE FAN COOLS IT DOWN AND THE INDICATOR GOES OFF.
-
Page 10: Maintenance And Troubleshooting
Maintenance and troubleshooting The following operation requires sufficient professional knowledge on electric aspects and comprehensive safety knowledge. Make sure the input cable of the machine is disconnected from the electricity supply and wait for 5 minutes before removing the machine covers. In order to guarantee that the arc welding machine works efficiently and in safety, it must be maintained regularly. -
Page 11: Machine Disposal
Malfunction Cause/Solution Turn on the machine, the power indicator illuminates, 1) The LED1 on the main board is on: The the control PCB keys work normally but there is no control PCB is damaged. response when pushing the torch trigger. 2) The LED1 on the main board is off: Check the torch trigger and torch trigger wire. - Page 12 Cut Series JP-45PWV Order code JP-45PWV © Wilkinson Star Limited A WILKINSON STAR LIMITED PRODUCT 01-19 ISSUE 1...