Table of Contents
Advertisement
Maintenance and
Support
Cleaning
Clean your system with rags and a soft
nylon brush. If desired, a mild detergent or
disinfectant can be used. Do not use sol-
vents or high pressure water to clean any
part of the system.
Maintaining Components
Camera Head
Scratches on the camera have a minimal ef-
fect on its performance. Do not use scraping
tools or sand the camera to remove scratch-
es.
Push Cable
Run a rag over the push cable and visually
inspect it for cuts and abrasions while push-
ing it back into the drum. Replace or repair
the push cable if the outer jacket is cut or
abraded.
Storage
The rM200 must be stored in a dry, secure
area between -40°C and 65°C [-40°F and
149°F]. Store your equipment in a locked
area out of the reach of children and people
unfamiliar with its purpose.
Support
For support and additional information
about using your system, visit support.
seesnake.com/rm200.
Service and Repair
Improper service or repair can cause the
camera reel to be unsafe to operate.
Service and repair of the camera reel must
be performed at a RIDGID Independent Au-
thorized Service Center. To find your near-
est service center or for any service or re-
pair questions:
• Contact your local RIDGID distributor.
• Visit RIDGID.com.
• Contact
Ridge
Technical
Service
rtctechservices@emerson.com or, in
the USA and Canada, call 1-800-519-
3456.
rM200 – English – 25
Tool
Company
Department
at
Advertisement
Table of Contents
