Emerson RIDGID SeeSnake Max rM200 Series Operator's Manual page 23

System Cable Removal
1. Disconnect the system cable from
the reporting monitor and remove the
monitor from the docking system.
2. Unwrap the system cable from the
cable wraps.
3. On the rear side of the rM200 case,
turn the slip-ring dial counter-clock-
wise to the unlocked position .
4. Pull straight out.
NOTICE
Do not touch the contact
pins inside the slip-ring
dial. Stressing the contact
pins can cause them to
break.
Broken Contact Pin
System Cable Installation
To install the system cable, follow these
steps:
1. Align the arrow on the slip-ring dial
with the unlock symbol
and insert the slip-ring dial into the
slip-ring cavity.
2. Turn the slip-ring dial to the locked po-
sition .
3. Hook the system cable into the frame
hook and snap the cable anchor onto
the frame.
4. Wrap the system cable around the
cable wraps.
rM200 – English – 23
on the frame