Table of Contents
Advertisement
5. Unwrap the SeeSnake system cable
from the cord wrap.
6. Slide all six case latches toward the
handle to unlock the rM200 case.
7. Lift handle to open.
Installing the Drum
The rM200 case gives you the ability to
swap out the drum when the job requires a
different push cable and camera combina-
tion.
To install the drum, follow these steps:
1. Open the rM200 case.
2. Place the drum in the rM200 case.
3. Make sure the bearing faces down
and the counter keypad faces up.
4. Spin the drum to make sure the drum
spins freely on the bearing.
5. Lock all six (6) of the rM200 case
latches.
The O-ring can fall out
NOTICE
easily. Make sure the
O-ring is properly in-
stalled before use.
Routing the Camera
If the camera is inside the drum, route the
camera through the drum access opening
and the push cable guide. Secure the cam-
era in the camera clip when not in use.
Inspection Overview
To perform a pipe inspection, connect any
See Snake monitor to the reel, power on the
system, push the push cable through the
pipe, and observe the display.
For advanced inspection options, such as
capturing media, locating the sonde, tracing
the push cable, and delivering reports, refer
to the manual that comes with your monitor.
Connecting to the Monitor
Connect the system cable to the monitor by
aligning the connector guide pin with the
socket and pushing the connector straight
in.
Only twist the outer lock-
NOTICE
ing sleeve. Never bend or
twist the connector.
Socket
Guide Pin
Outer Locking Sleeve
Retrieving the Camera
Pull the push cable back out of the pipe with
slow, steady force and feed small lengths
back into the drum. Wipe the push cable
with a paper towel or rag as you retrieve it.
Do not exert excessive
NOTICE
force or pull at sharp an-
gles.
lengths or forcing the
push cable may cause it
to loop, kink, or break.
rM200 – English – 15
Connector Ridge
Feeding
longer
Advertisement
Table of Contents
