Table of Contents
Advertisement
Programming
STYLE 2
Programming Mode
Allows operator to assign cook times, power levels, and stage cooking to the number
keypads.
From READY or DOOR OPEN screen:
1.
Press PROGRAM SAVE keypad.
• Programming mode begins.
• "Enter Program to Add/Review:" will display.
2.
Select the keypad(s) to change or review the program cooking sequence.
• Single Digit Keypad Cooking: Press a keypad (0-9).
• Double Digit Keypad Cooking: Press two keypads, in order, of the double digit
number for the desired cooking sequence (00-99).
3.
To enter Cooking Time: Press TIME ENTRY keypad.
• Press number keypads to enter cook time.
4.
To edit Power Level: Press POWER LEVEL keypad.
• Press number keypads to enter % microwave power
("0"=0%,"1"=10%, "2"=20%,etc.).
For 100% microwave power level, press any number keypad twice.
5.
To add additional cooking stages: Press STAGE keypad.
• Repeat steps 3-5 for each additional stage.
• Up to four stages can be entered.
6.
To save the cooking program: Press PROGRAM SAVE keypad.
7.
To discard changes: Press STOP/RESET keypad.
Quantity Keypad Programming
This feature allows a percentage of original cook time, called a cook factor, to
be added to a programmed cook sequence. Each time the quantity keypad is
pressed, the cooking time is increased by the user-specified percentage.
Each programmed cook sequence may be customized with a unique cook factor.
Note: The factory default cook factor is 80%. Cook factors may vary by model.
TO EDIT THE COOK FACTOR:
1.
Complete steps 1-5 in "Programming Mode" section.
2.
Select the keypad(s) to reprogram.
3.
Press QUANTITY (X8) keypad.
• Default of CF:80 displays.
• Press number keypads to enter desired cook factor
("0"=0%,"1"=10%, "2"=20%,etc.)
4.
To save the cooking program: Press PROGRAM SAVE keypad.
©2020 ACP, Inc.
Cedar Rapids, IA 52404
Page 20 of 24
SET A MID - CYCLE PAUSE
To add a pause to the middle of a
programmed cook sequence.
While in Programming Mode, after
entering Cooking Time or Power Level:
1.
Press HIDDEN keypad.
• A short beep sounds. This
indicates the program is set for a
mid-cycle pause.
2.
Continue programming as desired.
When preset program keypad is
used, pause will occur in the middle
of total programmed time. The oven
beeps continuously and PROGRAM
PAUSED displays until the oven door is
opened and closed again. To continue
the cooking cycle, press START/OK
keypad.
Part No. 20072103
Original Instructions
Advertisement
Table of Contents
