Table of Contents
Advertisement
Grounding & Installation
Grounding/Earthing Instructions
Oven MUST be grounded. Grounding reduces risk of electric shock
by providing an escape wire for the electric current if an electrical short
occurs. This oven is equipped with a cord having a grounding wire
with a grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded.
Consult a qualified electrician or servicer if grounding instructions are not completely understood,
or if doubt exists as to whether the oven is properly grounded.
DO NOT use an extension cord.
If the product power cord is too short, have a qualified electrician install a three-slot receptacle. This oven should be plugged into a
separate circuit with the electrical rating as provided in product specifications (available at www.acpsolutions.com) and the oven's
serial plate / rating label. When the oven is on a circuit with other equipment, an increase in cooking times may be required and fuses
can be blown.
EXTERNAL EQUIPOTENTIAL EARTHING TERMINAL (export only)
Equipment has secondary earthing terminal. Terminal provides external earthing connection used in addition to earthing
prong on plug. Located on outside of oven back, terminal is marked with symbol shown at right
Installation
Unpacking Oven
•
Inspect oven for damage such as dents in door or inside oven cavity.
•
Report any dents or breakage to source of purchase immediately.
DO NOT attempt to use oven if damaged.
•
Remove all packing materials from oven interior.
•
If oven has been stored in extremely cold area, wait a few hours before connecting
power.
Radio Interference
Microwave operation may cause interference to radio, television. Reduce or eliminate
interference by doing the following:
•
Clean door and sealing surfaces of oven according to instructions in
"Care & Cleaning" section.
•
Place radio, television, etc. as far as possible from oven.
•
Use a properly installed antenna on radio, television, etc. to obtain stronger signal
reception.
Oven Placement
•
DO NOT install oven next to or above source of heat, such as pizza oven
or deep fat fryer. This could cause oven to operate improperly and could shorten life
of electrical parts.
DO NOT block or obstruct oven filters. Allow access for cleaning.
•
•
Install oven on level counter-top surface.
•
If provided, place warning label in a conspicuous place close to oven.
•
Outlet should be located so that plug is accessible when oven is in place.
OVEN CLEARANCES
Allow at least 2" (5.1 cm) of clearance around top of oven. Proper air flow around
A.
oven cools electrical components. With restricted air flow, oven may not operate
properly and life of electrical parts is reduced.
B.
There is not an installation clearance requirement for the back of the oven.
C.
Allow at least 1" (2.54 cm) of clearance around sides of oven.
D.
Install oven so oven bottom is at least
©2020 ACP, Inc.
Cedar Rapids, IA 52404
A
C
(91.5 cm) above floor.
3 feet
D
Page 5 of 24
⚠
WARNING
To avoid risk of electrical shock or
death, this oven must be grounded and
plug must not be altered.
⚠
WARNING
Excessive Weight Hazard
Use two or more people to move and
install oven. Failure to do so can result
in back or other injury
A
C
D
INDIVIDUAL OVEN
(All models)
A
B
C
D
STACKING OVENS
(1700-2200 watt models only)
A
B
C
D
B
Part No. 20072103
Original Instructions
Advertisement
Table of Contents
