Programming; Programming Pads; Programming Multiple Stages - ACP JET Series Owner's Manual

Programming Pads

Oven is shipped from the factory for single digit programming. To change
the oven default to double digit programming, see User Option section. To
program the amount of time, power level, or temperature setting for a pad:
1. Oven must be ON.
• Press Preheat On/Off pad.
• Oven Preheating 475°F or 250°C shows in display
with Oven Preheating flashing.
2. Oven reaches preheat temperature.
• Ready 475°F or 250°C shows in display with Ready flashing.
Press Program Save pad.
• Programming mode begins.
• Enter Program to Add/Review: shows in display.
3. Press pad to be programmed or reprogrammed.
• Display will change to review all settings for the pad.
• The pad number that is being programmed displays beside the word
ITEM.
4. Press Time Entry pad to program amount of cooking time.
• Enter desired cooking time by using numeric key pads.
• The total microwave cooking time (all stages combined) is
20 minutes.
5. Press Temp Entry pad to program the cooking temperature.
• Enter desired convection temperature by using numeric
pads.
6. Press Power Level pad to program level of microwave
power.
• For a lower microwave power, press pads 1 (for 10%)
through 9 (for 90%). 0 turns off the microwave power
and cooking is by convection only.
• Press any numeric key pad twice to set power level back to 100%.
7. Press Program Save pad to save the program changes.
8. To discard changes, press Stop/Reset pad.

Programming Multiple Stages

Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory pad.
To use stage cooking:
1. Follow steps 1 through 6 above.
7. Press Stage pad.
• This will begin programming for the next cooking
stage.
• Display indicates stage to be programmed.
• Enter cook time, temp and power level as in steps 4. 5 and 6.
• To enter another cooking stage for that pad, press Stage pad
again.
• Up to four different stages can be programmed.
8. Press Program Save pad to save the program and
changes.
9. To discard changes, press Stop/Reset pad before
pressing Program Save pad.

Programming

Preheat Setting
The convection temperature setting
can be set between 150°F to 475°F
(65°C to 250°C). It is recommended
to set the preheat setting to the most
commonly used temperature for that
oven. The factory default preheat
setting is 475°F (250°C).
To program the preheat setting:
1. Turn oven on to set preheat.
2. Press Program Save pad.
3. Press Temp Entry pad.
4. Enter desired temperature by
5. Preheat temperature is changed.
several different cooking cycles, or
stages, to be used consecutively
without repeated input from the user.
Stage cooking can be set to defrost
food initially, then cook it, and then
keep the food warm until serving time.
7
Programming
using the numeric key pads.
• Temperature must be entered
in 5°F (5°C) increments. If
not, the temperature will
automatically change to the
nearest 5°F (5°C).
What is stage
cooking?
Stage cooking enables