Table of Contents
Advertisement
WWW.JEIUK.COM
19. Using the machine on surfaces that are rusty, covered with a thick paint layer, uneven,
or not stiff is prohibited.
20. Use the safety strap in all operating positions. The strap must be tight and fastened to a
securely fixed element either through the opening in the machine body or by catching
the strap on the carrying handle.
21. Before every use, inspect the machine to ensure it is not damaged. Check whether any
part is cracked or improperly fitted. Make sure to maintain proper conditions that may
affect the operation of the machine.
22. Always use eye and hearing protection and protective clothing during operation. Do not
wear loose clothing.
23. Proceed with caution when machining plates with thickness lower than 10 mm (0.4'') as
the adhesion force depends on material thickness and is significantly lower for thin
plates.
24. The whole surface of the electromagnetic base bottom must be in full contact with the
workpiece. Before every positioning, wipe the workpiece with coarse-grained
sandpaper.
25. Do not touch moving parts or chips formed during milling. Prevent objects from being
caught in moving parts.
26. After every use, remove metal chips and coolant remainder from the machine. Do not
remove chips with bare hands.
27. Maintain the machine and tools with care. Cover steel parts with a thin grease layer to
protect them against rust when not in use for any extended period.
28. Perform maintenance only with the machine unplugged from the power outlet.
29. Perform repairs only in a service center appointed by the seller.
30. If the machine falls on a hard surface, from height, is wet, or has any other damage that
could affect the technical state of the machine, stop the operation and immediately
send the machine to the service center for inspection and repair.
31. Never leave the machine unattended during operation.
32. Remove from the worksite and store in a secure and dry location when not in use,
previously removing the cutter from the arbor.
7
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.
This document is protected by copyrights.
Advertisement
Table of Contents
