Advertisement
Step 2:
Assemble the rear wall panels
You will find it easier to assemble your shed using sawhorses with timber studs attached (timber needs to be the same length as the
shed (3.0m) or alternatively, a trestle table.
Place 4 x part 6A (Sheet) on your worktable and then position parts 27I, 27H (top channel) and parts 27C, 27D (bottom channel) to
the sheeting by tapping (diagram A) or sliding them into place (diagram B). Make sure the small lip of the channel is always facing
out. This ensures rain water cannot build up inside your shed. Make sure parts 27I and 27H are used as top side channels as per
the diagram below.
RIDGES FACING UP
ROOF TOP EDGE
27H
27I
6A
6A
6A
6A
27D
27C
A
9
Advertisement
